Table 9-37 Cnfatmimagrp Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing PXM1E and AXSM Card Diagnostics
To configure ATM cell layer parameters on an IMA group, enter the cnfatmimagrp command as
follows:
cnfatmimagrp -grp <bay.group> -sps <
In the following example, the user enables payload scrambling and AIS on the ATM IMA group 14 on
the PXM1E in the lower bay.
Unknown.7.PXM.a > cnfatmimagrp -grp 2.14 -sps 1 -ais 1
Table 9-37

Table 9-37 cnfatmimagrp Command Parameters

Parameter
-grp <bay.group>
sps <PayloadScramble>
ais <aisMode>
Enter the dspatmimagrp <bay.group> command to display whether AIS and payload scrambling are
enabled or disabled for an IMA group, as shown in the following example:
Satire.2.PXM.a > dspatmimagrp 2.1
GrpNum
------- --------- --------------- ----------- --------------- -------
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
9-90
describes the parameters for the cnfimagrp command.
Description
The bay number and the IMA group number.
Note
Enable of disable payload scrambling. Default: enabled.
AIS is an all-ones signal that is transmitted instead of the normal
signal to maintain transmission continuity and to indicate to the
receiving terminal that there is a transmission fault that is located
either at the transmitting terminal or upstream from the transmitting
terminal.
Default = Enable
HCScoset PayloadScramble NullCellHdr NullCellPayload
2.1 Enable Disable
PayloadScramble
> -ais <aisMode>
bay: Enter 2 for the lower bay.
•
grp: 1-16
•
On the PXM1E, the bay number is always 2.
• 1 = enable
• 2 = disable
Enables or disables the alarm indication signal (AIS) mode. The
• 1 = Enable AIS transmitting.
• 2 = Disable AIS transmitting.
0x00000001
Chapter 9 Switch Operating Procedures
AIS
6a Enable
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004