Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 413

Chapter 9 Switch Operating Procedures
Table 9-23 Parameters for the cnfpart Command (continued)
Parameter
minVpi
maxVpi
minVci
maxVci
minConns
maxConns
available
connections
minDlci
maxDlci
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Description
Minimum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095.
This parameter applies only to PXM1E and AXSM cards.
Note
Maximum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095. The value for
<maxVpi> cannot be less than for <minVpi>.
This parameter applies only to PXM1E and AXSM cards.
Note
Minimum VCI number for this port. Enter a number in the range from 32 to 65535.
To support features planned for the future, Cisco recommends setting the minimum
VCI to 35 or higher.
This parameter applies only to PXM1E and AXSM cards.
Note
Maximum VCI number for this port. Enter a number in the range from 32 to 65535.
Note This parameter applies only to PXM1E and AXSM cards.
Specifies the guaranteed number of connections.
On the PXM1E UNI/NNI, the ranges vary according to the line types, as follows:
For OC3, T3, and E3 lines, the range is 10-27000.
•
• For T1 and E1 lines, the range is 10-13500.
On the AXSM series of cards, the range is 10 through the maximum number of
connections in the port group.
This parameter applies only to PXM1E and AXSM cards.
Note
Maximum number of simultaneous connections allowed on this port. The range is
the same as described for the <minConns> parameter. This parameter must be set
to number that is greater than the number defined for <minConns>.
Note This parameter applies only to PXM1E and AXSM cards.
Logical channel number. Range: 0–16000.
This parameter applies only to FRSM12 cards.
Note
Lowest data-link connection identifier (DLCI). A value that specifies the DLCI in
a Frame Relay network:
Two-byte header—Range: 1–1023
•
Four-byte header—Range: 0–8388607
•
The value specified must be n * 32768, where n is a number from 0 to 255.
Note This parameter applies only to FRSM12 cards.
Highest data-link connection identifier (DLCI). A value that specifies a DLCI in a
Frame Relay network:
• 2-byte header—Value range: 1 –1023
4-byte header—Value range: 0 –8388607
•
The value specified must be (n * 32768)-1, where n is a number from 1 to 256.
This parameter applies only to FRSM12 cards.
Note
Managing PXM1E Partitions
9-49