Cisco Igx Feeder To Mgx 8830 Or Mgx 8850 (Pxm1E) Configuration Quickstart - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Command
Step 8
uppnport <portid>
Related commands:
dsppnports
dsppnport <portid>
Step 9
Step 10 addcon <options>
Step 11

Cisco IGX Feeder to MGX 8830 or MGX 8850 (PXM1E) Configuration Quickstart

The quickstart procedure in this section provides a summary of the tasks required to configure a feeder
between a Cisco MGX 8850 (PXM1E) or Cisco MGX 8830 switch, and a Cisco IGX 8400 switch. This
procedure is provided as an overview and as a quick reference for those who have previously configured
these types of connections.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Purpose
Bring up the configured port.
If you are using CWM to manage your networks, the XLMI link
should be ready to use. Use CWM to add a connection from a
destination in the AutoRoute network to a destination in the PNNI
network.
If you are not using CWM to manage your networks, add a
connection from the XLMI link endpoint on the PXM1E to a
destination on the PNNI network.
The PNNI connection you create must use the same VPI
Note
and VCI as the connection defined in the AutoRoute
network.
See the "Provisioning and Managing SPVCs and
later in this chapter.
Connections added with the CLI (addcon) command
Note
cannot be managed by CWM. If you are using CWM,
create the connection with CWM. Afterwards, you can
modify the connection with CWM or the CLI.
If you are not using CWM to manage your networks, add a
connection from the XLMI link endpoint on the BXM to a
destination on the AutoRoute network.
Note The AutoRoute connection you create must use the same
VPI and VCI as the connection defined in the PNNI
network.
For more information, refer to the Cisco BPX 8600 Series
Installation and Configuration guide.
Quickstart Provisioning Procedures
SPVPs" section
3-19