Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 160

General PXM1E Configuration Procedures
M8830_CH.1.PXM.a > dspimagrps
Ima Min
Grp Lnks Frm
--------------------------------------------------------------------------------
2.1
Step 3 To display the configuration information for the particular IMA group that you want to configure, enter
the dspimagrp <group> command. The IMA group numbers are listed in the Ima Grp column. In the
following example, the user displays the IMA group 2.1.
M8830_CH.1.PXM.a > dspimagrp 2.1
Group Number
NE IMA Version
Group Symmetry
Tx Min Num Links
Rx Min Num Links
NE Tx Clk Mode
FE Tx Clk Mode
Tx Frame Len (bytes)
Rx Frame Len (bytes)
Group GTSM
NE Group State
FE Group State
Group Failure Status
Tx IMA ID
Rx IMA ID
Max Cell Rate (c/s)
Avail Cell Rate (c/s)
Diff Delay Max
Diff Delay Max Observed (msecs) : 0
Accumulated Delay (msecs)
Clear Accumulated Delay Status
GTSM Up Integ Time (msecs)
Type <CR> to continue, Q<CR> to stop:
GTSM Dn Integ Time (msecs)
Num Tx Cfg Links
Num Rx Cfg Links
Num Act Tx Links
Num Act Rx Links
Least Delay Link
Tx Timing Ref Link
Rx Timing Ref Link
Group Running Secs
Alpha Val
Beta Val
Gamma Val
Tx OAM Label
Rx OAM Label
Test Pattern Procedure Status
Test Link
Test Pattern
Stuff Cell Indication (frames)
Version Fallback Enabled
Auto-Restart Mode
Rx IMA ID Expected
Auto-Restart Sync State
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-32
Tx Rx Tx Diff
Frm Clk Delay
Len Len Mode (ms)
1 128 128 CTC 275
(msecs)
Chapter 3
NE-IMA
State
Operational
: 2.1
: 1.0
: Symm Operation
: 1
: 1
: CTC
: CTC
: 128
: 128
: Up
: Operational
: Operational
: No Failure
: 255
: 255
: 14367
: 14367
: 275
: 0
: Not In Progress
: 0
: 4000
: 4
: 4
: 4
: 4
: 2.4
: 2.4
: 2.1
: 3999077
: 2
: 2
: 1
: 1
: 1
: Disabled
: Unknown
: 255
: 1
: true
: disable
: -1
: disable
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Provisioning PXM1E Communication Links
FE-IMA IMA
State Ver
Operational 1.0