Starting A Cli Management Session Using A Cp Port Or Terminal Server Connection - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Appendix C Supporting and Using Additional CLI Access Options
To configure the IP interface to the LAN, you need to do the following:
•
•
The procedure you use to configure the ATM router will depend on the router you are using. The
following example lists commands you can use on a Cisco router to support IP over ATM
communications with the Cisco MGX switch.
Example C-2
config term
ip routing
ip route 0.0.0.0 0.0.0.0 W.X.Y.Z 1 (set default route)
interface atm 0
ip address A.B.C.D G.H.I.J
atm nsap-address 47.0091.8100.0000.0010.7b65.f258.0010.7b65.ffff.f1
atm uni-version 3.1
atm pvc 1 0 5 qsaal
atm pvc 2 0 16 ilmi #Optional. Enter to enable ILMI.
atm ilmi-keepalive 10 #Optional. Enter to configure ILMI.
atm esi-address 00107B65FFFF.F1 #Optional. Enter to support ILMI.
atm arp-server self
no shut
^Z
write memory
Starting a CLI Management Session Using a CP Port or Terminal
Server Connection
The process for starting a CLI management session is similar for both CP port and terminal server
connections. Both use a serial connection to the switch. The difference is that terminal server
connections require that you first select the correct port at the terminal server.
After switch initialization, you can terminate and start sessions at any time using the terminal or
workstation connection to the CP port or terminal server.
To start a CLI management session for CP port and terminal server connections, use the following
procedure.
Turn on the terminal or start the terminal session.
Step 1
For instructions on preparing the terminal and the connection, refer to the procedure in the previous
section.
Step 2 If you are accessing the switch through a terminal server, enter the commands that allow you to select
the serial port that leads to the switch.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
If the router IP address for the ATM interface is not on the same subnet as the IP address on the
switch ATM interface, you must manually configure on IP host-route for each MGX switch to which
the interface will connect.
Configure a routing protocol to broadcast the switch IP addresses to the LAN or create default routes
to the switch on the management workstation.
Router Configuration Commands for IP Communications over ATM
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide

Starting a CLI Management Session Using a CP Port or Terminal Server Connection

# G.H.I.J = netmask
C-11