Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 44

Documentation
Changes to This Document
Table 4
Table 4
Chapter
Chapter 1, "Preparing for Configuration"
Chapter 2, "Configuring General Switch
Features"
Chapter 3, "Provisioning PXM1E
Communication Links"
Chapter 4, "Preparing Service Modules for
Communication"
Chapter 5, "Preparing SRM Cards for
Communications"
Chapter 6, "Preparing RPM Cards for Operation"
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
xliv
summarizes the changes made to this guide since the previous release.
Changes to This Book Since the Previous Release
Changes
Added information about new manuals and
features and made minor revisions.
Added coverage for new hardware and made
minor revisions.
Note The former chapter titled "Planning for
Card Redundancy, Line Redundancy, and
Bulk Distribution" has been moved to the
Cisco MGX 8850 (PXM1E/PXM45),
Cisco MGX 8950, Cisco MGX 8830, and
Cisco MGX 8880 Hardware Installation
Guide, Releases 2 Through 5.
This chapter combined the information formerly
published in the following chapters: "Preparing
PXM1E Lines for Communication" and
"Provisioning PXM1E Communications Links."
This new chapter describes the procedure for
configuring general service module configuration
parameters. It replaces the following chapters:
Preparing AXSM Cards and Lines for
•
Communication
• Preparing FRSM12 Cards for
Communication
• Preparing Cell Bus Service Modules for
Communication
This chapter also provides information on the new
MPSM cards.
Note Information on AXSM line preparation
has been moved to the Cisco ATM
Services (AXSM) Configuration Guide
and Command Reference for MGX
Switches, Release 5.
This chapter has been updated to describe the new
SRME/B card.
Minor revisions.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
About This Guide