Manually Grooming Connections; Table 8-11 Parameters For Optrte Command - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing Connection Grooming
This example schedules grooming to occur at the default interval (60 minutes) between midnight and 4
a.m. on Mondays, Wednesdays, and Fridays:
M8850_LA.7.PXM.a > cnfrteopt 6:1.3:13 enable -tod 00:00..04:00 -weekday .M.W.F.
M8850_LA.7.PXM.a > dsprteoptcnf 6:1.3:13
Route Optimization Configuration:
---------------------------------
Percentage Reduction AW CBR:
Percentage Reduction AW RTVBR:
Percentage Reduction AW NRTVBR:
Percentage Reduction AW ABR:
Percentage Reduction AW UBR:
Percentage Reduction CTD CBR:
Percentage Reduction CTD RTVBR:
Percentage Reduction CDV CBR:
Percentage Reduction CDV RTVBR:
Absolute Cost AW CBR:
Absolute Cost AW RTVBR:
Absolute Cost AW NRTVBR:
Absolute Cost AW ABR:
Absolute Cost AW UBR:
Absolute Cost CTD CBR :
Absolute Cost CTD RTVBR :
Absolute Cost CDV CBR:
Absolute Cost CDV RTVBR:
Port
6:1.3:13

Manually Grooming Connections

Manual grooming, which is also called on-demand grooming, grooms one or more port connections
immediately. You can groom a specific connection by specifying the port ID, VPI, and VCI, groom a
range of connections, or groom all connections on the port. To manually groom the connections on an
port, enter the optrte command as follows:
M8850_LA.7.PXM.a > optrte <portid> [-vpi <vpi>] [-vci <vci>] [-range
<starting-vpi/vci..ending-vpi/vci>]
Table 8-11

Table 8-11 Parameters for optrte Command

Parameter
portid
vpi
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
8-38
Enable VPI/VCI Range
yes all
describes the optrte command parameters.
Description
Root endpoint port identifier, in the format
[shelf.]slot[:subslot].port[:subport]. To display a list of the available
ports, enter the dsppnports command.
When the -vpi option is specified, the optrte command grooms only
those port connections that use the specified VPI. To display a list of
connections that includes the VPI and VCI for each connection, enter the
dspcons command.
Chapter 8
30
30
30
30
30
30
30
30
30
0
0
0
0
0
0
0
0
0
Interval Time Range
60 00:00..04:00 .M.W.F.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Managing PNNI Nodes and PNNI Routing
Weekday(s)