Adding An Ima Port - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Table 3-6
-uplods <lodsUpTime>
-dnlods <lodsDnTime>
In the following example, the user configures link 2.5 so that it has an LIF up time of 25000 milliseconds,
an LIF downtime of 1000 milliseconds, an LODS integration up time of 25000 milliseconds, and an
LODS integration down time of 1000 milliseconds.
MGXswitch.7.PXM.a > cnfimalnk -lnk 2.5 -uplif 25000 -dnlif 1000 -uplods 25000 -dnlods 1000
Enter the dspimalnk <link> command to verify the configuration of the new IMA link.
Step 4

Adding an IMA Port

Once you have configured an IMA group, you need to add an IMA port to the group to enable ATM
services on that IMA group. Use the following procedure to add an IMA port to an IMA group.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Get the group number on which you will add the port. To display a list of the IMA group numbers, enter
Step 2
the dspimagrps command.
Verify that the port number you want to use is not already configured. To display a list of the configured
Step 3
ports on the PXM1E card, enter the dspports command.
Port numbers appear in the ifNum (interface number) column. The interfaces listed include UNI and NNI
ports. Choose a port number that is not already in use.
To add an ATM port to an IMA group, enter the following command:
Step 4
mgx8830a.1.PXM.a > addimaport <ifNum> <group> <guaranteedRate> <maxRate> <sctID> <ifType>
[vpi <vpi>] [-minvpi <minvpi>] [-maxvpi <maxvpi>]
Table 3-7
Note
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
cnfimalnk Command Parameters (continued)
lists the parameter descriptions for adding IMA ports.
Refer to Figure 3-4 earlier in this chapter to see the relationship between logical interface
numbers and physical lines.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
General PXM1E Configuration Procedures
Link Out of Delay Synchronization (LODS)
integration up time. The LODS is a link event
indicating that the link is not synchronized with
the other links within the IMA group.
Range 0-25000 milliseconds.
LODS integration down time.
Range 0-25000 milliseconds.
3-37