Chapter 9
Switch Operating Procedures
Enter the dspdiagstat command to display the number of times that the diagnostics has run. The output
shows the number of attempts and the number of failures for both offline and online diagnostics.
Unknown.7.PXM.a > dspdiagstat 7
Slot 7 diagnostics statistics:
online diag attempted
online diag passed
online diag failed
offline diag attempted = 0x00000000
offline diag passed
offline diag failed
Enter the dspdiagstatus command to display the diagnostics status and role (active or standby) for each
card on the switch. The diagnostics statuses are:
•
•
•
•
Enter the dspdiagstatus command as shown in the following example:
Unknown.7.PXM.a > dspdiagstatus
Slot
----
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Type <CR> to continue, Q<CR> to stop:
Enabling and Disabling IMA Group ATM Cell Layer Parameters
The cnfatmimagrp allows you to enable and disable the following ATM cell layer parameters on an IMA
group:
•
•
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
= 0x00001a26
= 0x00001a26
= 0x00000000
= 0x00000000
= 0x00000000
Idle—Slot is in an idle state because there is no card in the slot, or due to an error.
Ready—Card is active and ready for diagnostics test.
Offline—Card is offline.
Online—Card is online,
State
Role
-----
----
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Ready
ACTIVE CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Ready
ACTIVE CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
Idle
UNKNOWN CARD ROLE
payload scrambling
AIS
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Managing PXM1E and AXSM Card Diagnostics
9-89