Displaying An Sntp Server; Deleting An Existing Sntp Server; Managing Ncdp Clock Sources - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 9 Switch Operating Procedures
Table 9-12 Objects Displayed for dspsntp Command (continued)
Parameter
rollback:
stratum (default): Shows the default stratum level.
stratum (current): Shows the current settings for the stratum level.
sync:

Displaying an SNTP Server

Enter the dspsntprmtsvr command at the active PXM prompt to display a specific SNTP server.
ses.1.PXM.a > dspsntprmtsvr 172.29.52.88
Enter the dspsntprmtsvr
SNTP servers in the network.
M8850_NY.8.PXM.a > dspsntprmtsvr all

Deleting an Existing SNTP Server

Enter the delsntprmtsvr <IP_address> command at the active PXM prompt to delete a specific SNTP
server. Replace <IP_address> with the IP address of the server you want to delete.
M8850_LA.8.PXM.a > delsntprmtsvr 172.29.52.88
Enter the delsntprmtsvr all command to delete all SNTP servers on the network, as shown in the
following example:
M8850_LA.8.PXM.a > delsntprmtsvr all

Managing NCDP Clock Sources

The following sections provide procedures for managing Network Clock Distribution Protocol (NCDP)
clock sources.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Description
When a client switches over to the secondary server for TOD requests, the rollback
timer takes affect and continues polling the primary server for TOD each time the
rollback timer expires. The rollback timer continues polling the primary server
until it comes back up.
Default = 1024
Shows whether the SNTP client and server are in sync.
all
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
command at the active PXM prompt to display a list of all existing
Managing NCDP Clock Sources
9-31