Deleting A Default Cug Address; Managing Access Between Users In The Same Cug; Table 8-21 Setcugdefaddr Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing CUGs

Table 8-21 setcugdefaddr Command Parameters

Parameter or
Option
atm-address
length
plan
Step 3 Enter the dspcugdefaddr <portid
<portid
example.
mgx8830a.1.PXM1.a > dspcugdefaddr 6:1.1:11

Deleting a Default CUG Address

Enter the clrcugdefaddr <portid
<portid
example:
mgx8830a.1.PXM1.a > clrcugdefaddr 6:1.1:11

Managing Access Between Users in the Same CUG

When a user is assigned to a CUG, the default configuration allows the user to initiate outgoing
connections to other CUG members and to receive incoming connections from other CUG members. Use
the following procedure to disable incoming or outgoing connections to other group members for a
specific CUG, or to remove restrictions and enable communications with other CUG members.
Establish a configuration session using a user name with SUPER_GP privileges or higher.
Step 1
Step 2 Enter the dspcug command as follows to display the current CUG access configuration for a prefix or
address:
mgx8830a.1.PXM1.a > dspcug <atm-address> <length> <plan> <cug-index>
Note
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
8-60
Description
Replace this parameter with the NSAP or E.164 address or prefix of a local UNI
interface.
If the AESA or prefix you are assigning to a CUG uses the NSAP format, specify
the address length in bits. A full AESA is 160 bits (20 bytes times 8 bits). A shorter
address length indicates an ATM address prefix, which assigns all addresses with
that prefix to the CUG you specify.
If the prefix or AESA you are assigning to a CUG uses the E.164 format, specify
the prefix or address length in digits.
If the prefix or AESA you are assigning to a CUG uses the NSAP format, specify
nsap.
If the prefix or AESA you are assigning to a CUG uses the E.164 format, specify
e164.
with the appropriate port identifier in the format slot:bay.line:ifnum, as shown in the following
>
>
with the appropriate port identifier in the format slot:bay.line:ifnum, as shown in the following
>
The dspcug command is described in the
appears earlier in this document.
Chapter 8
command to verify a new default CUG address assignment. Replace
>
command to delete a default CUG address assignment. Replace
"Displaying CUG Configuration
Managing PNNI Nodes and PNNI Routing
Data" section, which
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004