Displaying Detailed Command Lists - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 2 Configuring General Switch Features
To display a list of commands that include a common set of characters, enter a question mark and the
common set of characters, as shown in the following example:
M8850_LA.8.PXM.a > ? ip
M8850_LA.8.PXM.a >

Displaying Detailed Command Lists

Detailed command lists display the following additional information for each command:
•
•
•
Note To display detailed command lists, you must establish a session using a username with SERVICE_GP
privileges or higher (access privileges are described later in this chapter in the
Access" section). You can also find this information in the Cisco MGX 8850 (PXM45/PXM1E), Cisco
MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Command Reference, Release 5.
To enable detailed command lists, log in as a user at the CISCO_GP level and enter the clidbxlevel
command as shown in the following example:
mgx8850a.7.PXM.a> clidbxlevel 1
Value of cliDbxLevel is now 1
Note Beginning with Release 5, the clidbxlevel command is not available in the default configuration. To
enable access to this command, log in as a user at the CISCO_GP level and enter the seteng on
command. The seteng command enables and disables (seteng off) access to commands that are intended
for use by Cisco engineers.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Available commands
------------------
cnfifip
cnfilmiproto
cnftrapip
delifip
dspifip
dspipconntask
dspipif
dspipifcache
dsptrapip
ipifconfig
pntracevsipkt
setipconndebug
zip
Access level required to enter the command
Card state in which the command can be entered
Whether command execution is logged
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Getting Command Help
"Configuring User
2-13