Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual page 255

Chapter 6 Preparing RPM Cards for Operation
The following example shows the dspcd command display for an RPM-PR card:
M8850_LA.8.PXM.a > dspcd 9
M8850_LA
MGX8850
Slot Number:
Inserted Card:
Reserved Card:
State:
Serial Number:
Prim SW Rev:
Sec SW Rev:
Cur SW Rev:
Boot FW Rev:
800-level Rev:
800-level Part#:
CLEI Code:
Reset Reason:
Card Alarm:
Failed Reason:
Miscellaneous Information:
Type <CR> to continue, Q<CR> to stop:
M8850_LA
MGX8850
Crossbar Slot Status:
Alarm Causes
------------
NO ALARMS
Backcard Mismatch Reasons
-------------------------
Upper Card
----------
NO MISMATCH
Lower Card
----------
NO MISMATCH
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
System Rev: 04.09
9 Redundant Slot: NONE
Front Card
----------
RPM_PR
RPM_PR
Active
SAK0419001H
---
---
12.3(1.7)T1
12.2(7.4)T
10
800-07178-01
BAA6PT0CAA
On Reset From Shell
NONE
None
System Rev: 04.09
No Crossbar
Understanding dspcds and dspcd Displays for RPM
Jul. 17, 2003 22:48:11 GMT
Node Alarm: CRITICAL
Upper Card Lower Card
---------- ----------
4E_B_RJ45 FE_RJ45
UnReserved UnReserved
Active Active
SBK051700VX SBK0512013X
--- ---
--- ---
--- ---
--- ---
B0 B1
800-12134-01 800-02735-02
BAEIABGAAA BAEIAAAAAA
Jul. 17, 2003 22:48:11 GMT
Node Alarm: CRITICAL
6-3