Table 3-17 Parameters For The Addcon And Cnfcon Commands - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Tip The configuration of SPVCs and SPVPs is very similar. The difference is that SPVPs are assigned VCI 0
and do not use nonzero VCI numbers. An SPVC requires a nonzero VCI.
Configuring the Slave Side of SPVCs and SPVPs
To configure the slave side of an SPVC or SPVP, use the following procedure.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Define the slave side of the SPVC by entering the following command:
Step 2
PXM1E_SJ.8.PXM.a > addcon <ifNum> <vpi> <vci> <serviceType> <mastership>
[-slave atmAddr.vpi.vci] [-lpcr <cellrate>] [-rpcr <cellrate>] [-lscr <cellrate>]
[-rscr <cellrate>] [-lmbs <cells>] [-rmbs <cells>] [-lcdv <time>] [-rcdv <time>]
[-lctd <time>] [-rctd <time>] [-lmcr <cellrate>] [-rmcr <time>]
[-cdvt <time>] [-cc <1|0>] [-stat <1|0>] [-frame <1|0>] [-mc <maxCost>]
[-lputil <percentage>]
[-slavepersflag <persistent|nonpersistent>]
[-prefrte <preferredRouteId>]
[-extvsvd <external vsvd config>][-directrte <directRoute>]
Caution Once you create an SPVC connection, you cannot change the SPVC prefix until all SPVC connections
have been deleted. The procedure for changing the SPVC prefix is described in the
the SPVC
Table 3-17
terms used in
the other end of the connection. If you omit an option, the SPVC uses the default value.

Table 3-17 Parameters for the addcon and cnfcon Commands

Parameter
ifNum
vpi
vci
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
[-rputil <percentage>]
Prefix" section in Chapter 2, "Configuring General Switch Features."
lists and defines the parameters and options for the addcon command. The local and remote
Table 3-17 refer to settings for the local port you are configuring and the remote port at
Commands
addcon, cnfcon
addcon, cnfcon
addcon, cnfcon
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
[-rtngprio <routingpriority>]
[-intvsvd <internal vsvd config>]
Description
Enter the interface number (which is defined with the
addport command) for the port to which this SPVC will
connect. The range is from 1 to 31.
Enter the VPI for the slave side of the SPVC.
UNI Range: 0 to 255.
NNI Range: 0 to 4095.
Enter the VCI for the slave side of the SPVC or SPVP.
SPVC Range: 32 to 65535.
SPVP Range: 0.
Note Cisco recommends setting the minimum VCI to 35
or higher. Future products will use VCI 32 through
34 for other services.
General PXM1E Configuration Procedures
"Setting and Viewing
3-71