Table 3-9 Parameters For Addport And Cnfport Commands - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Step 4 To add an ATM port to a line, enter the following command:
mgx8830a.1.PXM.a > addport <ifNum> <bay.line> <guaranteedRate> <maxRate> <sctID> <ifType>
[vpi <vpi>] [-minvpi <minvpi>] [-maxvpi <maxvpi>]
Table 3-9
logical interface numbers and physical lines.
Table 3-9
Parameter
ifNum
bay
line
guaranteed
Rate
maxRate
sctID
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
lists the parameter descriptions for adding ports.
Parameters for addport and cnfport Commands
Description
An ATM port is also called an interface. An ATM port is defined by its slot, bay, line,
and interface numbers. You do not have to enter a slot number during port configuration
because you identify the slot number when you select the card.
Enter a number from 1 to 31 to identify this interface. For UNI and NNI ports, you can
assign one logical interface per line.
Replace <bay> with 2 to indicate the lower bay.
Replace <line> with the number that corresponds to the back card port to which the line
is connected.
Enter the minimum rate for the port in cells per second (cps).
The <guaranteedRate> value should equal the <maxRate> value.
Note
The rate ranges for PXM1E are as follows:
OC3: 50 – 353207.
T3: 50 – 96000 (PLCP) or 104268 (ADM).
E3: 50 – 80000.
T1: 50-3622 cps
E1: 50-4528 cps
Enter the maximum rate for the port in cps.
The <maxRate> value should equal the <guaranteedRate> value.
Note
The rate ranges are as follows:
OC3: 50 – 353207.
T3: 50 – 96000 (PLCP) or 104268 (ADM).
E3: 50 – 80000.
T1: 50-3622 cps
E1: 50-4528 cps
Enter a registered PXM1E port SCT number. To display a list of all the registered SCTs,
enter the dspscts command. For guidelines on selecting an SCT, refer to the
SCTs" section in Chapter 7, "Managing Service Class Templates."
General PXM1E Configuration Procedures
Figure 3-4 shows the relationship between
"Cisco
3-45