Display A Specific Ncdp Clock Source; Table 9-17 Dspncdpclksrc Command Objects - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 9 Switch Operating Procedures
Table 9-16 dspncdp Command Objects (continued)
Parameter
Last clk src change time
Last clk src change reason

Display A Specific NCDP Clock Source

Enter the dspncdpclksrc command to display configuration information about a specific NCDP clock
sources on the network.
M8850_LA.8.PXM.a > dspncdpclksrc 7.35
Best clock source
Priority
Stratum level
Primary reference src id
Health
M8850_LA.8.PXM.a >
Table 9-17

Table 9-17 dspncdpclksrc Command Objects

Parameter
Best clock source
Priority
Stratum Level
Primary reference
src id
Health
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
describes the objects displayed by the dspncdpclksrc command.
Description
Describes whether the specified clock source is currently the best clock source
in the node.
Displays the specified clock source's priority.
Stratum level of the specified clock source. Possible levels are 1, 2E, 2, 3E, 3,
4E, or 4.
Displays the specified clock sources ID.
Describes the current health of the specified clock source. The possible health
states ar described below.
Good—Specified clock source is the current root clock or the second best clock
source, and is in good condition.
Bad—Specified clock source was the root clock at some point, but went bad
and is no longer available.
Wideband-Locking—Specified clock source is being qualified by the clock
manager and is in wideband-locking mode.
Narrowband-Locking—Specified clock source is being qualified by the clock
manager and is in narrowband-locking mode.
Unknown—Specified clock source is not the root clock source.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Description
Time when the root clock source last changed.
Reason why the root clock source last changed.
: No
: 100
: 2
: 0(external)
: Bad
Managing NCDP Clock Sources
9-37