Deleting A Pxm1E Resource Partition - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Managing PXM1E Partitions
Table 9-23 Parameters for the cnfpart Command (continued)
Parameter
ingPctBw
egrPctBw
Step 4 To display the changed partition configuration, enter the dsppart command as described in the previous
section.
Note
Step 5 Display the available controllers with the dspcontrollers command, and write down the controller
settings for the controller you are about to delete. For example:
mgx8830a.1.PXM.a > dspcontrollers
Step 6 Enter the delcontroller command to delete the controller that corresponds to the resource partition you
modified. For example:
pop20two.7.PXM.a > delcontroller 3
All Ports and Connections
delcontroller: Do you want to proceed (Yes/No)? y
To register the resource partition changes, add the deleted controller with the addcontroller command.
Step 7
For example:
pop20two.7.PXM.a > addcontroller 3 i 3 7 "PNNI Controller"
Step 8 To verify that the controller was added correctly, enter the dspcontrollers command.

Deleting a PXM1E Resource Partition

To delete a resource partition, you must do the following:
•
•
The following procedure explains how to delete a resource partition.
Step 1 Establish a configuration session using a user name with CISCO_GP privileges.
To display a list showing the partitions for this card, enter the dspparts command.
Step 2
Note the interface number and partition number for the resource partition you want to delete.
Step 3
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
9-50
Description
Percentage of ingress bandwidth available to the connection. Range: 0–100
percent.
This parameter applies only to FRSM12 cards.
Note
Percentage of egress bandwidth available to the connection. Range: 0–100 percent.
This parameter applies only to FRSM12 cards.
Note
The current software release does not support dynamic changes to partitions. To begin using
changes to a resource partition, you need to delete the controller and then add the controller as
described in the Step 5 through Step 8 of this procedure.
on this controller will be deleted.
Delete any connections that are using the affected port
Bring down the affected port
Chapter 9 Switch Operating Procedures
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004