Improving And Managing Rerouting Performance; Pure Pxm45/C Networks; Hybrid Networks With Pxm45/C And Pxm45/B; Pure Pxm45/B Networks Running Version 3.0.10 Or Later - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Multiservice switch
Table of Contents

Advertisement

Managing PNNI Routes
The following example sets the deroute delay to 20 seconds and uses the dsppnportloscallrel command
to verify the configuration change:
PXM1E_SJ.7.PXM.a > cnfpnportloscallrel 7:2.10:10
PXM1E_SJ.7.PXM.a > dsppnportloscallrel 7:2.10:10
Deroute Delay: 30 seconds
Call release on Los :enabled

Improving and Managing Rerouting Performance

The following sections provide some guidelines for improving and managing rerouting performance for
the following network configurations:

Pure PXM45/C Networks

To improve rerouting performance in a pure PXM45/C based network, Cisco recommends entering the
following commands on the active PXM45/C in each switch:
To improve rerouting over specific NNI links, enter the following PXM45 commands at both ends of
each link:
These parameters are recommended only for the PXM45/C cards and not for the PXM45, PXM45/B or
Note
PXM1E cards.

Hybrid Networks with PXM45/C and PXM45/B

If the recommended settings for a pure PXM45/C network are used in a network that contains PXM45/B
cards, the PXM45/B nodes can experience CLI lockout as a result of the volume of connections set up
by the PXM45/C cards. CLI lockout is a condition where switch response to CLI commands is very slow
because the switch is overloaded with other tasks.
For hybrid networks with PXM45/C and PXM45/B nodes, consider upgrading the PXM45/B nodes or
limit the performance of the PXM45/C nodes to that of the PXM45/B nodes.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
8-24
Pure PXM45/C Networks
Hybrid Networks with PXM45/C and PXM45/B

Pure PXM45/B Networks Running Version 3.0.10 or Later

Hybrid Networks with PXM45/C and PXM45/A
cnfnodalcongth -setuphi 1200
cnfnodalcongth -connpendhi 2400 -connpendlo 2000
cnfnodalcongth -incompjour 30
cnfintfcongth <physical port> -setuphi 500
cnfpnctlvc <physical port> sscop -scr 3000
Chapter 8
Managing PNNI Nodes and PNNI Routing
yes -delay 30
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8950Mgx 8830Mgx 8880

Table of Contents