Bringing Up A Connection; Bringing Down A Party; Bringing Up A Party; Rerouting Connections - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links

Bringing Up a Connection

Bringing up a connection routes a P2P connection or all parties on a P2MP connection. To bring up a
connection, enter the upcon command using the following format:
PXM1E_SJ.8.PXM.a > upcon <portid> <vpi> <vci>
Replace the portid, vpi and vci parameters with the values that uniquely identify the connection to be
brought up. You can locate these parameters by entering the dspcons command. When bringing up a
P2MP connection, the upcon parameters must identify the root connection endpoint.

Bringing Down a Party

Bringing down a party deroutes a single party on a P2MP connection. To bring down a party, enter the
dnparty command using the following format:
PXM1E_SJ.8.PXM.a > dnparty <portid> <vpi> <vci> <epref>
The dnparty command parameters are the same parameters you set with the addparty command
(Table

Bringing Up a Party

Bringing up a party reconnects a previously downed party to the P2MP root connection. To bring up a
party, enter the upparty command using the following format:
PXM1E_SJ.8.PXM.a > upparty <portid> <vpi> <vci> <epref>
The upparty command parameters are the same parameters you set with the addparty command
(Table

Rerouting Connections

Rerouting a connection reroutes a P2MP connection or all parties on a P2MP connection. To reroute a
connection, enter the rrtcon command using the following format:
PXM1E_SJ.8.PXM.a > rrtcon <portid> <vpi> <vci>
Replace the portid, vpi and vci parameters with the values that uniquely identify the connection to be
rerouted. You can locate these parameters by entering the dspcons command. When rerouting a P2MP
connection, the rrtcon parameters must identify the root connection endpoint.

Rerouting a P2MP Party

The following procedure provides detailed steps for rerouting a party.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 At the active PXM1E prompt, enter the dspparties command to display all parties on the node.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
3-18).
3-18).
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
General PXM1E Configuration Procedures
3-87