Static Multicast Routing - Edge-Core AS6700-32X Cli Reference Manual

Static Multicast Routing

ip igmp snooping vlan
mrouter
Table 119: show ip igmp snooping statistics vlan query - display description
Field
Warn Rate Limit
V1 Warning Count
V2 Warning Count
V3 Warning Count
This section describes commands used to configure static multicast routing on
the switch.
Table 120: Static Multicast Interface Commands
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Chapter 22
Description
The rate at which received query messages of the wrong version type
cause the Vx warning count to increment. Note that "0 sec" means that
the Vx warning count is incremented for each wrong message version
received.
The number of times the query version received (Version 1) does not
match the version configured for this interface.
The number of times the query version received (Version 2) does not
match the version configured for this interface.
The number of times the query version received (Version 3) does not
match the version configured for this interface.
Function
Adds a multicast router port
Shows multicast router ports
– 605 –
| Multicast Filtering Commands
Static Multicast Routing
Mode
GC
PE