Setting Up The Base And Charging Cradle (If Included); Connecting The Base - Siemens Gigaset C590 Manual

First steps

Setting up the base and charging cradle (if included)

The base and charging cradle are designed for use in enclosed dry rooms with a
temperature range of +41°F to +113°F.
¤
Install the base on a level, non-slip surface in a central location in your house or
flat or mount the base or charging cradle on the wall (
Please note
Pay attention to the range of the base.
This is up to 984 feet in unobstructed outdoor areas and up to 165 feet inside
buildings. The range is reduced when Eco Mode (
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u
Protect your telephone from moisture, dust, corrosive liquids and fumes.

Connecting the base

¤
First connect the
power adapter 1.
¤
Then connect the
telephone jack
and insert the cables
into the cable ducts.
Please note:
u
The power adapter
must always be connected, as the phone will not operate without electrical
power.
u
Only use the power adapter and phone cord supplied. Pin connections on tele-
phone cables can vary (
10
2
2
1
¢
page 55).
¢
page 65).
¢
page 41) is activated.
1
1