Bico Technology: Interconnecting Signals - Siemens sinamics dcp Operating Instructions Manual

Operation
8.1 Operation
Important parameters
p0977:
p0802:
p0803:
p0804:
Safely removing a memory card
Removing the memory card must be requested using p9400.
Procedure:
p9400 = 2
p9400 = 3
p9400 = 100
p9400 = 0
Note
If the memory card is removed without a request being made, this can destroy the file
system on the memory card.
8.1.1.5

BICO technology: Interconnecting signals

Every SINAMICS DCP contains a large number of interconnectable input and output
variables and internal control variables.
The SINAMICS DCP can be adapted to a wide range of requirements using BICO
technology (Binector Connector Technology).
Digital and analog signals, which can be interconnected as required by means of BICO
parameters, are identified by the prefix BI, BO, CI, or CO in their parameter name.
These parameters are identified accordingly in the parameter list or in the function diagrams.
Note
The STARTER commissioning tool is recommended when using BICO technology.
118
Save all parameters (for details, see the SINAMICS DCP List Manual).
Data transfer of parameters [0, 10, 11, 12], memory card as source or target
Data transfer of parameters [0...100], non-volatile device memory as source or
target
Start of parameter data transfer and specification of transfer direction:
p0804 = 1: Transfer from the memory card to non-volatile device memory
p0804 = 2: Transfer from non-volatile device memory to memory card
Request to "safely remove" the memory card
Feedback: "You can safely remove the memory card"
Remove the memory card
Feedback: "It is not possible to safely remove the memory card"
The SINAMICS DCP is accessing the memory card. Leave the memory card
in the unit and try again later.
Message: No memory card inserted
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP