Siemens sinamics dcp Operating Instructions Manual page 98

Commissioning
7.3 Commissioning with the STARTER commissioning tool
Image 7-21
Alternatively, the download to the target system can also be performed as follows:
● Step 1
Select the menu command Target system > Download > Project to target system
Selection in the toolbar
Note
Your project data has now been transferred to the drive unit. Presently, this data is only in
the volatile memory (RAM) of the drive unit, however, neither saved in the non-volatile
memory (ROM) nor on an optionally inserted memory card (see also Memory card
functions (Page 113)).
To save your project data in the ROM and on the optionally available memory card of
your drive unit so that it is protected against power failure, carry out the following steps.
● Step 2
Select the menu command Target system > Target system > Copy RAM to ROM
Selection in the toolbar
Note
The button for copying RAM to ROM can only be activated if the drive unit has been
marked in the project navigator.
98
Download
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP