Ethernet/Ip; Connection Of Sinamics Dcp With Ethernet/Ip To Ethernet Networks; Configuration Of Sinamics Dcp For Ethernet/Ip; Setting The Ip Address And Activating The Ethernet/Ip Protocol - Siemens sinamics dcp Operating Instructions Manual

Operation

8.7 EtherNet/IP

8.7 EtherNet/IP
Note
This chapter applies to several components of the SINAMICS drive family. These include the
SINAMICS DCP even though it is not a drive. Therefore, in this chapter, the terms "drive,"
"drive unit," or "drive system" always refer to the SINAMICS DCP.
8.7.1

Connection of SINAMICS DCP with EtherNet/IP to EtherNet networks

8.7.1.1 Connection of SINAMICS DCP with EtherNet/IP to EtherNet networks
The SINAMICS DCP version with option G33 (Profinet CBE20) is required for the connection
to EtherNet/IP. See Chapter Ordering information for options and accessories (Page 28) for
ordering data.
For further details on the CBE20 module, see Chapter Option Board: Communication Board
EtherNet CBE20 (Page 57).
8.7.2

Configuration of SINAMICS DCP for EtherNet/IP

8.7.2.1

Setting the IP address and activating the EtherNet/IP protocol

Requirements
● Version with option G33 (PROFINET CBE20)
● MMC memory card with firmware version as of 1.2 to load the CBE20 firmware for
EtherNet/IP to the CBE20. The CBE20 firmware is installed as standard for PROFINET.
See also the information on the hardware/software compatibility in the preface.
● CBE20
The IP configuration is performed via STARTER or through direct parameter input via the
BOP.
Table 8- 32
Parameter
p8941
p8943
p8942
218
Settable parameters on the drive object CU
IP address
Subnet screen
Default gateway
Note
Setting is mandatory
Setting is mandatory
-
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP