Siemens sinamics dcp Operating Instructions Manual page 124

Operation
8.1 Operation
Information on the keys
Table 8- 5 Keys
Key Name
ON
OFF
Functions
Parameters The meaning of these keys depends on the current display.
Higher
Lower
BOP20 functions
Table 8- 6 Functions
Name
Backlight
Switch active drive
Units
Access level
Parameter filter
Select status display
User parameter list
124
Switching on
Binector output r0019.0 is set using this key.
Switching off
The binector outputs r0019.0, .1 and .2 are simultaneously reset when this key is pressed. After
the key has been released, binector outputs r0019.1 and .2 are again set to a "1" signal.
Note:
The effectiveness of these keys can be defined via BICO parameterization.
The meaning of these keys depends on the current display.
Note:
The effectiveness of this key to acknowledge faults can be defined via BICO parameterization.
If this key is pressed for 3 s, the "Copy RAM to ROM" function is executed. The "S" displayed on
the BOP disappears.
The keys depend on the current display and are used to either increase or decrease values.
The backlight can be set using p0007 in such a way that it switches itself off automatically
after the set time if no actions are carried out.
From the BOP perspective, the active drive is defined using p0008 or using the keys "FN" and
"Arrow up".
The units are not displayed on the BOP.
The access level for the BOP is defined using p0003.
The higher the access level, the more parameters can be selected via the BOP.
The parameter filter in p0004 can be used to filter the available parameters in accordance with
their particular function.
Actual values and setpoints are displayed on the status display.
The status display can be set via p0006.
Using the user parameter list in p0013, parameters can be selected for access.
Meaning
Description
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP