Siemens sinamics dcp Operating Instructions Manual page 260

Operation
8.15 Drive Control Chart (DCC) for SINAMICS DCP
The following applies for STARTER V4.4 SP1:
– The technology package TPdcblib_SINAMICS_4_6.3.0 (version V4.60.07.00) is
Note
Only version V4.60.07.00 enables DCC on the SINAMICS DCP, but not all other versions
(e.g. V4.60.06.00 or V4.70.07.00).
3. Loading of the technology package TPdcblib_SINAMICS_4_6.3.0 (version V4.60.07.00)
to the SINAMICS DCP
– Installation via the STARTER shortcut menu to the SINAMICS DCP:
4. Create a DCC chart on the PC (using the DCC editor)
See
5. Compile the DCC chart on the PC and load it to the SINAMICS DCP
– Compile via the shortcut menu of the DCC chart:
– Load the SINAMICS DCP via the STARTER menu:
Ramp-up time
If DCC is installed in the SINAMICS DCP, the ramp-up time increases by approx. 10 s.
260
already included in the STARTER scope of delivery. It is also installed automatically
with the STARTER installation.
Select technology packages ...
Execute "Download"
Remark:
This action takes about 7 minutes.
Article
SINAMICS/SIMOTION DCC editor
(https://support.industry.siemens.com/cs/ww/en/view/99005147)
Motion control, SINAMICS/SIMOTION, description of the
Standard DCC Blocks
(https://support.industry.siemens.com/cs/ww/en/view/99000356)
Accept and compile
Project > Download to target system
Note
If in the menu"Options > Settings..." the checkbox "Compile all programs before
loading" is activated under the "Download" heading, the manual "Accept and compile"
can be omitted.
Article number
6SL3097-4AN00-0AP2
6SL3097-4AQ00-0AP3
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP