Siemens sinamics dcp Operating Instructions Manual page 263

Miscellaneous
● Free function blocks and a DCC chart can be used at the same time.
● If you load a DCC chart to the SINAMICS DCP, although the technology package
TPdcblib_SINAMICS_4_6.3.0 is not available in the SINAMICS DCP, then it signals an
error. To correct this error, proceed as follows:
– Install the technology package TPdcblib_SINAMICS_4_6.3.0 as described above.
– Then carry out a POWER OFF/ON.
– Load the STARTER project together with the DCC chart to the SINAMICS DCP.
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
8.15 Drive Control Chart (DCC) for SINAMICS DCP
Operation
263