Components - Siemens sinamics dcp Operating Instructions Manual

6.3

Components

Fuses
The device must be protected by DC fuses on the input side and output side.
Suggested type
For the 30 kW device:
Siemens PV fuse 63 A with designation 3NE1218-4
Fuse holder: Siemens 3NH7262-4KK01
Alternative fuse (with UL certification): Ferraz Shawmut/Mersen: A150X60-4
For the 120 kW device:
Siemens PV fuse 250 A with designation 3NE1227-4D
Fuse holder: Siemens 3NH7260-4
Alternative fuse (with UL certification): Ferraz Shawmut/Mersen: A150X250-4
Line contactors
Recommended type
Relevant to the 30 kW device:
Gigavac HX21 C A (with UL certification)
This type is only a single-pole contactor, which means that, to switch two poles, 2 contactors
are required for each current path.
The power contactors must be able to handle 1000 V and 50 A.
Relevant to the 120 kW device:
Gigavac HX21 C A (with UL certification)
This type is only a single-pole contactor, which means that, to switch two poles, 2 contactors
are required for each current path.
The power contactors must be able to handle 1000 V and 200 A.
Precharging resistors
Recommended type
CAV 150 C 100R 800, manufacturer: Danotherm company
Note
Using this precharging resistor will result in the following precharging times:
30 kW device: 65 ms
120 kW device: 600 ms
This must be taken into account in the parameterization (p55355).
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
Electrical connection
6.3 Components
43