Siemens sinamics dcp Operating Instructions Manual page 84

Commissioning
7.3 Commissioning with the STARTER commissioning tool
Image 7-7
Note
PG/PC is the only master on bus must be activated if no other masters (PC, S7, etc.) are
available on the bus.
Note
Even if no PROFIBUS interface is installed in the PC, projects can be generated and
PROFIBUS addresses for the drive objects can be assigned.
Only the bus addresses available in the project will be offered. That prevents double bus
address assignments.
⇒ After completion, click OK to confirm the setup and to return to the project wizard.
84
Setting up the interface - properties
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP