Siemens sinamics dcp Operating Instructions Manual page 123

Information on the displays
Table 8- 4 Displays
Display
Top left
2 digits
RUN
Top right
2 digits
S
P
C
Bottom 6 digits
For certain user actions (e.g. restore factory setting) a two-digit number is displayed on the
BOP20. This number provides information about the SINAMICS DCP state. The meaning of
these numbers is provided in the BOP20 status display during ramp-up (Page 73).
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
Meaning
The active drive object of the BOP is displayed here.
The displays and key operations always refer to this drive object.
Lights up when the SINAMICS DCP is in the RUN state (operation).
RUN is also displayed via bit r0899.2.
The following is displayed in this field:
More than 6 digits: Characters that are still present but are invisible (e.g. "r2" ––> 2 charac-
•
ters to the right are invisible, "L1" ––> 1 character to the left is invisible)
Designation of BICO inputs (bi, ci)
•
Designation of BICO outputs (bo, co)
•
Source object of a BICO interconnection to a drive object different than the active one.
•
Lights up if at least one parameter was changed and the value was not transferred to the non-
volatile memory.
Lights up if the parameter value does not become effective until the P key is pressed.
Lights up if at least one parameter was changed and the calculation for consistent data man-
agement has still not been initiated.
Displays parameters, indices, faults and alarms.
Operation
8.1 Operation
123