Siemens sinamics dcp Operating Instructions Manual page 248

Operation
8.14 Diagnostics
Note
The LEDs can only be seen when the front cover of the SINAMICS DCP is opened.
CUD - Response of LEDs during a software update
Table 8- 33 Software update
RDY DP1
Red Off
Red Red
2 Hz
Red Red
0.5 Hz 0.5 Hz
Red Red
2 Hz 2 Hz
Orange x
0.5 Hz
Orange x
2 Hz
CUD - Response of LEDs during ramp-up (following Power On)
Table 8- 34 Ramp-up
RDY DP1
Red Red
Red Red
2 Hz
Red Red
2 Hz 2 Hz
Red Orange
flashing
Red Off
Off Red
248
LED
OPT MOD
Off Off
Off Off
Off Off
Off Off
x Off
x Off
LED
OPT MOD
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Software being updated.
Software on the memory card is incomplete or defective.
The software was not successfully updated. The CRC of the pro-
grammed firmware is incorrect.
Software was successfully updated. The electronic power supply
must be switched off and back on again.
The software on the memory card does not belong to SINAMICS
DCP.
Software version and hardware version of the CUD are not com-
patible. For information on the hardware/software compatibility,
see Chapter Upgrading the device software (Page 273).
DRIVE-CLiQ component is being updated.
DRIVE-CLiQ component has been updated.
State
BIOS loaded
BIOS error
File error
Firmware loading
Firmware loaded
No CRC error
Operating Instructions, 05/2016, A5E34382853K
Meaning
Remark
-
-
Memory card not present or
flash file system faulty
DP1 flashing without specific flashing
frequency
-
Firmware checked
SINAMICS DCP