Commissioning
7.3 Commissioning with the STARTER commissioning tool
Settings
1. In STARTER, from Project > Set PG/PC interface, select the Serial cable (PPI) interface.
If this is not available in the drop-down list, you first have to add it using Select.
Note
If the interface cannot be added to the selection menu, the drive for the serial interface
still needs to be installed.
This is located in the following path on the STARTER CD:
\installation\starter\starter\Disk1\SerialCable_PPI\
STARTER must not be active while the driver is being installed.
2. Enter the following settings. The "0" address and the transmission rate 19.2 kbit/s are
important here.
Image 7-23
100
Setting the interface
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP