Writing And Reading Parameters With Class 4Xx - Siemens sinamics dcp Operating Instructions Manual

Operation
8.7 EtherNet/IP
8.7.4

Writing and reading parameters with Class 4xx

As described in Chapter Class 0x401 - 0x43E Writing and reading of parameters (Page 224),
individual drive parameters can be read and written.
In order to use this function, a "MSG" message block must be inserted in the program (figure
below). A control tag of the "MESSAG" type must be declared and assigned to the message
block for saving the configuration and status information.
The class information is assigned to the block in the next step. The configuration dialog must
be opened by clicking (1).
Image 8-61
The configuration dialog shown in the following figure opens:
Image 8-62
228
Inserting MSG
Configuration dialog
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP