Siemens sinamics dcp Operating Instructions Manual page 114

Operation
8.1 Operation
Note
The memory card supplied from Siemens as option S03 includes, when supplied, a copy of
the internal device software. These files are required for software updates. These files can
be deleted for other applications.
Before you use the card for the functions described in this chapter, copy these files to a local
folder of your PG/PC and delete the files on the memory card.
Parameter data sets
Parameter data sets represent all of the parameters of a project - including the DCC charts
and the project itself. The parameter data sets differ depending on configuration and
application.
Different data volumes can be saved in the three memory areas:
● ROM: Four parameter data sets with the indices 0, 10, 11, and 12
● The parameter data set with the index 0 is active in the RAM
● Memory card: Depending on the free storage space, up to 101 parameter data sets
(indices 0 to 100)
Note
The DCC library itself is not saved as a part of the parameter data set.
114
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP