Appendix D: Optional Accessories Introduction; Label Rewinder - SATO M-5900RV Operator And Technical Reference Manual

Optional Accessories
Introduction

Label Rewinder

PN 9001081
Rev. C
This section contains instructions for using the following M-5900RV optional
features:
• Label Rewinder
• Label Cutter
• Label Dispenser
• PCMCIA Memory Cards
• Calendar
The rewinder is an external unit that allows for labels and tags to be rewound
in rolls up to 8.5 inches in diameter. It derives its power directly from the
printer's EXT connector using a built-in cable. The rewinder provides the
ability to rewind tags/labels from the printer and subsequently be unwound
for later use with applicators.
Installation
1. Position the Rewinder at the front of the printer and align it with the
label slot. The Rewind Wheel/Spindle should be positioned away from
the printer.
2. Connect the built-in cable from the Rewinder to the EXT connector at
the rear of the printer.
3. On the Rewinder, remove the metal clamp from the Rewind Spindle.
4. .eed the lead end of the label stock under the first spindle and onto the
Rewind Spindle. .eed the stock around the spindle once, then replace
the metal clamp over the label stock. Wind another revolution to
ensure the labels are secure on the spindle.
5. Select the REWIND option on the rewinder, then set the power switch
to ON. The printer must be powered ON for the rewinder to function.
Removing and Unwinding the Roll
As labels are printed, tension from the rewinder should keep the label
stock taut as it wraps itself on the spindle.
SATO M-5900RV Operator and Technical Reference Manual
Appendix
,
Page D-1