Programming The Control For Phone Access; Ring Detection Count Chart - ADEMCO Vista-10SEa Installation And Setup Manual

VISTA-10SEa Installation and Setup Guide

Programming the Control for Phone Access

1. With at least one keypad (set to the Non-addressable mode, address 31) connected to the
keypad terminals on the control, power up the system temporarily. If you previously
connected the mains plugpack to the control panel, you need only plug it in to the mains
(to 230VAC outlet) to power up the system.
NOTE: The 4285/4286 has a permanent device address of 4.
2. Enter the programming mode by keying the following on the keypad:
1 1 1) + 8 + 0.
3. Press 26 VOICE (PHONE) MODULE ACCESS CODE.
Enter the 2-digit phone access code as follows: For the first digit, enter 1–9; for the
second digit, enter [#] +11 for " ," or # +12 for "#."
Example: If desired access code is 7 , 7 is the first entry, and [#] + 11
(for ) is the second entry.
Enter 00 if not using a phone module (this is the default).
NOTE: A "0" in either digit will disable a phone module.
4. Press 95 RING DETECTION COUNT FOR DOWNLOADING.
Refer to the chart below and program this field accordingly.
If you are using
(Yes) or not
using (No)
Phone Module
Yes
Yes
Yes
Yes
If you enter 15 in field 95 to bypass an answering machine, and a 4285/4286 Phone Module is
included in the installation, you should note the following:
When calling in from an off-premises phone (to receive a status report or execute a command),
the user should make the initial call, allow 1 to 3 rings only, hang up, and then call in again. The
phone module will now seize the line, and the user will hear 2 long tones, followed by the usual
voice prompt for the 2-digit phone access code. If this procedure is not followed, phone module
operation will not be possible.
5. You should also program Zone Descriptors, regardless of the type of keypads in use. If
this is not done, the phone module will not annunciate a description of the zone(s) in
8-4

Ring Detection Count Chart

...and if you are ...and if you
using (Yes) or are (Yes) or
not using (No) are not (No)
Answering
Machine Downloading
No
Yes
No
Yes
...then program Field 95 this way:
No Set for value other than "0" (1-14). This
will enable the control panel to answer the
phone call. Otherwise, it will not be
possible to access the phone module.
No Set for a value higher than the number of
rings for which the answering machine is
set.
Example: If the machine is set for 4 rings,
use a value of 5 or higher. This is
recommended so that the phone module
can still be accessed if the answering
machine is turned off and does not answer
the phone call.
Yes Set for a value other than "0" (1-14).
Yes Enter "15" to bypass the answering
machine. See Important Note below.
Installer code (4