Registration Solenoid Assembly (Turn Clutch) Failure - Xerox DOCUPRINT N17 Service Manual

7.4.18 Registration Solenoid Assembly (Turn Clutch) Failure

1 There is +24VDC between J27-3 and J17-2 on the LVPS.
Y: Go to step 2.
N: Go to RAP 7.4.7 Low Voltage Power Supply (LVPS) Assembly Failure (+24VDC).
NOTE: Disconnect P/J15 from the Print Engine Controller and perform the analysis.
2 In standby, there is +24VDC between P/J133-2 and P/J17-2.
Y: Go to step 3.
N: Replace the Feed Harness (P/J133-1 and P/J27-4).
3 In standby, there is +24VDC between P/J133-1 and P/J17-2.
Y: Go to step 4.
N: Replace the Registration Solenoid.
4 In standby, there is +24VDC between P/J27-4 and P/J17-2.
Y: Go to step 5.
N: Replace the Feed Harness (P/J27 to P/J133).
5 In standby, there is +24VDC between P/J11-5 and P/J17-2.
Y: Go to step 6.
N: Replace the LVPS.
6 In standby, there is +24VDC between P/J13-9 and P/J17-2.
Y: Go to step 7.
N: Replace the LVPS Harness.
7 The voltage between P/J27-4 and P/J17-2 on the LVPS is 0VDC when the Registration Solenoid
is actuated, and +24VDC when deactuated.
NOTE: You can inspect this while performing the Diagnostic Mode 1, Registration Solenoid.
Y: Replace the Registration Solenoid Assembly.
N: Replace the Print Engine Controller.
Xerox DocuPrint N17 Service Manual
6/98
www.printcopy.info
7-61 Repair Analysis Procedures (RAPs)