4.6 Paper Transportation II
4.6.1 Toner Sensor
Removal
NOTE: Carefully note the routing of the wiring harness.
1 Pull the Toner Sensor Assembly towards the front from the rear while lifting upward on the Toner
Sensor Assembly.
2 Disconnect the connector from the Toner Sensor (P137). (See Figure 4.6.1.1.)
3 Disengage the three clips, lifting up the Toner Sensor.
Replacement
Perform the removal steps in reverse order.
Repair/Adjustment Procedures
Figure 4.6.1.1 Toner Sensor Removal
SAS419F.CDR
6/98
www.printcopy.info
4-24
sas419fa
Xerox DocuPrint N17 Service Manual