Elevator Belt Adjustment - Xerox DOCUPRINT N17 Service Manual

12.3.10 Elevator Belt Adjustment

Whenever the Rear or Front Elevator Belts are replaced or paper feed problems are occurring, the follow-
ing check must be made to ensure that the paper feed tray is level.
Check
1. Open the feeder drawer and remove all paper.
2. Disconnect the AC Power Cord from the High Capacity Feeder.
3. Remove the four screws that secure the Rear Access Cover. Remove the access cover.
4. Disconnect J5, J7, and J9 and slide the drawer fully open.
5. Release the latches on the drawer rails and remove the drawer from the cabinet.
6. Place the drawer on a suitable work surface.
7. Using a 12" ruler, measure the distance at "a" and "b"—measurement is made from the Paper Tray
surface to the top of the drawer frame. (Figure 12.3.10.1) The two measurements should be within 1/
16".
NOTE: The check is made by direct measurement to ensure that the tray remains parallel to the to the
top of the drawer frame, and properly positioned to the feed components. The check is not made
with a spirit level because a "level" check is relative to the tray location, i.e., in the drawer,
extended on the rails, and therefore unreliable.
High Capacity Feeder Option
a
b
Figure 12.3.10.1 Elevator Belt Check
6/98
www.printcopy.info
12-20
adj_01
Xerox DocuPrint N17 Service Manual