Inlet Chute Assembly - Xerox DOCUPRINT N17 Service Manual

Hide thumbs Also See for DOCUPRINT N17:

Table of Contents

4.6.2 Inlet Chute Assembly

1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).

2 Free the Toner Sensor wire harness from the Inlet Chute Assembly.

3 Remove the two screws securing the Inlet Chute Assembly. (The screw on the right was already

removed in step 1.)

4 Bias the Inlet Chute Assembly towards the right and slightly towards the rear in order to clear the

bosses at the left side of the Chute Assembly. Lift upward and remove the assembly.

Perform the removal steps in reverse order.

Xerox DocuPrint N17 Service Manual

Figure 4.6.2.1 Inlet Chute Assembly Removal

www.printcopy.info

Repair/Adjustment Procedures

Table of Contents