11.3.10 No Paper Actuator
Removal
1. Remove the Feed Roll Assembly-1 (REP 11.3.9).
NOTE: It is not necessary to remove the Feed Roll Assembly-2. or Feed Belt.
2. Press the No Paper Actuator from the side of the surface on which envelopes are stacked toward the
bottom. This will remove the No Paper Actuator from the retaining tabs of the lower Bearing.
3. Slide the No Paper Actuator off the upper bearing hole.
SAS4CFFA
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Figure 11.3.10.1 No Paper Actuator Removal
6/98
www.printcopy.info
11-21
FRONT
Envelope Feeder Option