Organization - Xerox DOCUPRINT N17 Service Manual

Organization

This manual is divided into twelve sections. The
title and description of each section of this service
manual is as follows:
Section 1 - Service Call Procedures
This section is used to identify a suspected
problem. It contains Call Flow, Initial Actions, and
Final Actions. This part of the service manual
should always be used to start the service call.
Section 2 - Printer Specifications
This section contains all the printer specifications
for the Xerox DocuPrint N17 Network Laser
Printers.
Section 3 - Parts List
This section contains illustrations of disassembled
subsystems and a listing of the spared parts.
Section 4 - Repair/Adjustment Procedures
This section contains the instructions for removal,
replacement, and adjustment of the spared parts.
Section 5 - General Procedures/Information
This section contains diagnostic routines, printer
setup procedures, and a listing of tools and
supplies.
Section 6 - Wiring Data
This section contains illustrations of the plug/jack
locations and the routing of power and signal
cables.
Section 7 - Repair Analysis Procedures (RAPS)
This section contains the procedures necessary to
repair failures in the printer. This section also
contains the procedures necessary to
troubleshoot copy quality problems.
Section 8 - 500-Sheet Paper Feeder Option
This section contains Specifications, Parts List,
REPs, Wiring Diagrams, Troubleshooting, and
RAPs information for the 500-Sheet Paper Feeder
option.
Organization
Section 9 - Offset Catch Tray (OCT) Option
This section contains Specifications, Parts List,
REPs, Wiring Diagrams, Troubleshooting, and
RAPs information for the OCT option.
Section 10 - Duplex Module Option
This section contains Specifications, Parts List,
REPs, Wiring Diagrams, Troubleshooting, and
RAPs information for the Duplex Module option.
Section 11 - Envelope Feeder Option
This section contains Specifications, Parts List,
REPs, Wiring Diagrams, Troubleshooting, and
RAPs information for the Envelope Feeder option.
Section 12 - High Capacity Feeder
This section contains Specifications, Parts List,
REPs, Wiring Diagrams, Troubleshooting, and
RAPs information for the High Capacity Feeder
option.
Conventions
This manual uses the following names and
acronyms interchangeably.
• The "Multi-Sheet Bypass Feeder" (MBF) is
also referred to as the "Front Tray."
• "Trays" are also referred to as "cassettes."
• The "Print Engine Controller" is also referred
to as the "MCU" or the "AMCU."
• "Tray 1" is also referred to as the "250 Sheet
Feeder" or "Main Tray."
• "Offset Catch Tray" (OCT) is also referred to
as the "Offset Bin."
• "Stack" or "stacker" are also referred to as
"Bin."
6/98
www.printcopy.info
xii Xerox DocuPrint N17 Service Manual