Fusing; Fuser Assembly (Cru) - Xerox DOCUPRINT N17 Service Manual

Hide thumbs Also See for DOCUPRINT N17:

Table of Contents

4.8 Fusing

1 Remove the Duplex Module, if installed. ( REP 10.3.1 Duplex Module .)

2 Remove the two Fuser Module anchor screws. (See Figure 4.8.1.1.)

3 Grasp the Fuser Assembly by the peach felt tabs on both ends; then remove the Fuser Assembly

by firmly pulling it towards you.

1 Perform the removal steps in reverse order.

2 If a new Fuser Assembly was installed, reset the Fuser Life Counter.

3 Turn on the printer power while simultaneously pressing the ONLINE (0) and MENU DOWN (5)

keys. When the counter is reset, a row of black boxes will appear on the LCD screen and you may

release the keys.

Repair/Adjustment Procedures

Figure 4.8.1.1 Fuser Assembly (CRU) Removal.

www.printcopy.info

Xerox DocuPrint N17 Service Manual

Table of Contents