Deck One Switch Assembly - Xerox DOCUPRINT N17 Service Manual

12.3.2 Deck One Switch Assembly

Removal
1. Disconnect the AC Power Cord from the High Capacity Feeder.
2. Disconnect and remove the printer from the feeder.
3. Remove the four screws that secure the Rear Access Cover (Figure 12.3.2.1). Remove the access
cover.
4. Disconnect J5 from the Feeder Controller PWB (Figure 12.3.2.1).
5. Slide the feeder drawer open.
6. Cut the cable tie that secures the switch harness to the feeder frame.
7. Remove the two screws that secure the switch assembly to the feeder frame(Figure 12.3.2.1).
Remove the switch.
7
Replacement
1. Perform the removal steps in reverse order.
High Capacity Feeder Option
Figure 12.3.2.1 Deck One Switch Assembly
6/98
www.printcopy.info
12-12
3
4
Xerox DocuPrint N17 Service Manual
rep_02