Skew - Xerox DOCUPRINT N17 Service Manual

Skew

Observe the Printer Engine Controller test pattern. Measure the dimensions 'A' and 'B' on two
consecutive test patterns and check the following, Figure 7.5.3.8. The difference between 'A' and
'B' should be no more than 1.5 mm from any source.
The skew on the test patterns meets the specification.
Y: The printed test patterns meet the Skew specification. Go to the Skips and Smears
checkout on the next page.
N: Go to RAP 7.5.22 Skewed Image.
A
Repair Analysis Procedures (RAPs)
Figure 7.5.3.8 Print Engine Controller Test Pattern
Direction of Paper Travel
190mm
www.printcopy.info
•
7/99
7-86 Xerox DocuPrint N17 Service Manual
B