Character Defects - Xerox DOCUPRINT N17 Service Manual

Hide thumbs Also See for DOCUPRINT N17:

Table of Contents

7.5.12 Character Defects

the jjf jdj k adjfkjf9 ajdai0i asuod

sdajffi ouwuoiioirpai

ljafpdf oasdkf od odafkfddfduw

90kvajirtjoj 9j0i0l-e3wyh

Initial Actions

Generate a printer Configuration Sheet. Ask the customer to verify that the printer and host

settings match.

Ensure that the host interface cable meets specification. The maximum parallel cable length

is 10 ft. (3.0 meters).

Optional Interface: Refer to the network specifications for the environment where the printer

is installed.

1 Disconnect the host interface cable. Generate System Controller Test Prints (see 5.2.5 System

Controller Test Print ). The test prints are acceptable.

Y: Go to step 2.

N: Replace the System Controller.

2 Inform the customer that they may have bad font data. Ask the customer to reload the font.

3 The job prints correctly.

Y: Problem resolved.

N: Go to RAP 7.6 Communications Entry RAPs.

Repair Analysis Procedures (RAPs)

Garbled print, missing, repeating, or scrambled characters are

problems relating to font data or character generation. These are print

defects not related to the xerographic process.

www.printcopy.info

Xerox DocuPrint N17 Service Manual

Table of Contents