Insert Tray X Message (C3) - Xerox DOCUPRINT N17 Service Manual

Hide thumbs Also See for DOCUPRINT N17:

Table of Contents

7.3.11 "Insert Tray X" Message (C3)

1 Ensure the Size Sensor Assembly shows a correct switch combination for the size of the print

sheets present in Tray 1 when the tray presses the Size Sensor Assembly Spring.

NOTE: Ensure the paper guide in the back of the tray is adjusted properly.

NOTE: Remove Tray 1, and perform a visual inspection while inserting the tray into the slot.

Go to step 2.

N: Replace Tray 1.

2 The parameter for the Diagnostic Mode 1 (Paper Tray Size) is compatible with the switch

combination shown on the Size Sensor Assembly.

NOTE: You can inspect this by changing the position of the Size Spring.

Replace the Print Engine Controller.

N: Go to RAP 7.4.15 Size Sensor Assembly Failure.

Xerox DocuPrint N17 Service Manual

www.printcopy.info

Repair Analysis Procedures (RAPs)

Chapters

Table of Contents