Xerox DOCUPRINT N17 Service Manual page 189

Code
E4
E3
E2
Xerox DocuPrint N17 Service Manual
Display Conditions
1. The Exit Sensor is not deactu-
ated in the specified time after
the actuation of the Registration
Sensor.
2. The Exit Sensor is being actu-
ated when the printer is switched
on.
3. The Exit Sensor is being actu-
ated when an Interlock Switch is
closed.
4. The Exit Sensor is actuated
during an Erase Cycle.
The Exit Sensor is not actuated
within the specified time after the
actuation of the Registration
Sensor.
1. The Registration Sensor is
actuated before the specified
time after the actuation of the
Feed Roll Clutch (Too Soon
Jam).
2. The Registration Sensor is not
actuated within the specified time
after the actuation of the Feed
Roll Clutch (Misfed Jam).
3. The Registration Sensor is
being actuated when the printer
is switched on.
4. The Registration Sensor is
being actuated when an interlock
switch is closed.
5. The Registration Sensor is
actuated during an Erase cycle.
www.printcopy.info
Printer Action
The printer immediately
shuts down the Main
Motor, Laser Motor, and
the power supply to the
Fuser.
When the actual paper
length is greater than the
paper length detected,
however, the printer
ejects the paper and then
stops the Main Motor.
The printer immediately
shuts down the Main
Motor, Laser Motor, and
the power supply to the
Fuser.
When the actual paper
length is greater than the
paper length detected,
however, the printer
ejects the paper and then
stops the Main Motor.
For the first sheet of
paper, the printer immedi-
ately shuts down the Main
Motor, Laser Motor, and
the power supply to the
Fuser.
For the second and fol-
lowing sheet of paper, the
printer complete the cur-
rent print cycle and then
shuts down the Main
Motor, Laser Motor, and
the power supply to the
Fuser.
3/99
5-75
Recovery
Procedures
Open the Front or
Rear Cover, remove
the jamming paper,
then close the cover.
Open the Front or
Rear Cover, remove
the jamming paper,
then close the cover.
Open the Front or
Rear Cover, remove
the jamming paper,
then close the cover.
General Procedures/Information