Bin Full Sensor Failure - Xerox DOCUPRINT N17 Service Manual

7.4.14 Bin Full Sensor Failure

1 There is +5VDC between P/J28-1 and P/J28-3.
Y: Go to step 2.
N: Go to RAP 7.4.5 Low Voltage Power Supply (LVPS) Assembly Failure (+5VDC).
2 There is +5VDC between P/J125-1 and P/J125-3.
Y: Go to step 3.
N: Replace the Stack Full Sensor Harness.
3 The voltage between P/J28-2 and P/J28-1 is at a low logic level (0VDC) when the sensor detects
that the tray is not full and at a high logic level (+5VDC) when it detects a full tray.
Y: Replace the Print Engine Controller.
N: Go to step 4.
4 Verify continuity of the Stack Full Sensor Harness. The harness is good.
Y: Replace the Stack Full Sensor.
N: Replace the Stack Full Sensor Harness.
Repair Analysis Procedures (RAPs)
6/98
www.printcopy.info
7-56 Xerox DocuPrint N17 Service Manual