Fuser Pwb - Xerox DOCUPRINT N17 Service Manual

4.12.5 Fuser PWB

Removal
1 Remove the BTR Chute Assembly ( REP 4.7.2 BTR Chute Assembly ).
2 Remove the System Controller Chassis ( REP 4.12.1 System Controller Chassis ).
3 Disconnect P3 from the LVPS. (See Figure 4.12.5.1.)
4 Disconnect P115 from the HVPS.
5 Remove the wire harnesses from the rear, and slide the PWB Fuser out of the channel.
Replacement
Perform the removal steps in reverse order.
Repair/Adjustment Procedures
Figure 4.12.5.1 Fuser PWB Removal
SAS468F.CDR
6/98
www.printcopy.info
4-60
SAS468F
Xerox DocuPrint N17 Service Manual